2011-2016 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved 4 POWER STROKE FORD SUPERDUTY Installing The Pillar Pod SECTION 5 1. Carefully remove the factory trim from the truck by removing the bolt covers with a flat blade screwdriver and remove the two 7mm pillar retaining bolts. 2. Wrap Teflon Tape around the 1/8-27 NPT threads on the back of the Boost gauge, then attach the boost line adapter using a 13mm Wrench. Note: Do not overtighten. 3. Mount the gauges in the triple pillar gauge pod in any configuration you prefer. There is no specific order required. 4. Feed the wires from each gauge into the pillar pod. 5. If you are using the optional 3 Gauge Wiring Kit, attach all of the wires together. 6. Connect all of the yellow wires using splice connectors. 7. Connect all of the red wires using splice connectors. 8. Connect all of the orange wires using splice connectors. This enables the dimming function that will lower the brightness of your gauges 30% for easier viewing when driving at night. 9. Connect all of the black wires using splice connectors. 10. Secure all wires with Zip Ties. 11. Route the sensor wires and boost line through the firewall and into the cab of the truck, keeping clear of any moving parts. Note: You may need to drill a hole in the firewall if there isn’t one already. It is important to use a grommet on the hole to ensure the wires are not sliced or cut on the firewall. 12. Insert the boost line into the Ferrule Fitting Adapter, thread onto the back of the gauge and tighten with a 3/8” Wrench. (Refer to diagram below) Note: Do not overtighten the Ferrule Fitting. 2. 5-10. PROPER ORIENTATION 13. Plug the EGT Sensor Harness into the back of the EGT Gauge. (If used) 14. Splice the green signal wire from the Transmission Temperature Gauge to the green signal wire from the sensor. (If used) 15. Plug the Fuel Pressure Sensor Harness into the back of the Fuel Pressure Gauge. (If used) 16. Mount the pillar pod to the truck cab A-pillar, securing it with the supplied pillar mounting bolt and a 3mm Allen key.
RkJQdWJsaXNoZXIy MTIxODAy