2011-2016 Ford Super Duty 6.7L Powerstroke GlowShift Install Guide

2011-2016 INSTALLATION GUIDE 5 GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved POWER STROKE FORD SUPERDUTY 1. Reconnect the negative terminals of the two batteries to prepare power for the gauges and to test the fuses for power with a Test Light or multimeter. 2. Attach expandable circuits to both the yellow wire and the red wire. 3. Route the wiring to the passenger side footwell and secure the wires with Zip Ties. Make sure the wires are not near the pedals. 4. Connect the black wire to a reliable, clean, and unpainted ground source. There is an 8mm grounding screw behind the glove box. 5. Remove the passenger side kick panel by unclipping the spring tabs to gain better access to the Fuse Box. 6. Connect the yellow wire to the 20amp horn #22 fuse inside the Fuse Box. 7. Connect the red wire to the 10amp auxiliary switches #44 fuse inside the Fuse Box. 8. Connect the orange wire to 10amp parking lamps (in mirrors) roof marker lamps #40 fuse inside the Fuse Box. 9. Power up the truck to confirm that the gauges are functioning properly and check for any leaks or loose sensor connections. With the vehicle running, cycle through the gears to help the transmission fluid circulate through the transmission. Top off any fluids if necessary. 10. Press the Color Change Button on the gauges to ensure they are working correctly. Note: MaxTow Gauges do not change colors. The button allows you to change the 3 Daytime and 3 Nighttime Brightness Levels. 11. Test drive your vehicle to ensure all gauges are functioning properly. Note: The Boost Gauge will only read while driving. Connecting To Power SECTION 6 4. 6-8. 12.

RkJQdWJsaXNoZXIy MTIxODAy