1998-2002 Dodge Ram Cummins 5.9L Cummins Gauge Install Guide

1998.5-2002 INSTALLATION GUIDE 7 GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved DODGE RAM 24V 5.9L CUMMINS 1. Now that all of your gauges are mounted, you can proceed with the installation of your pillar pod. 2. Remove the lower dash panel using a Phillips-head screwdriver in order to cleanly route the wires. 3. Route the wires through the firewall and into the cab of the truck, keeping clear of any moving parts. Note: You may need to drill a hole in the firewall if there isn’t one already. It is important to use a grommet on the hole to ensure the wires are not sliced or cut on the firewall. 4. Insert the boost line into the Ferrule Fitting Adapter, thread onto the back of the gauge and tighten with a 3/8” wrench. (Refer to diagram below) Note: Do not overtighten the Ferrule Fitting. 5. Plug the EGT Sensor Harness into the back of the EGT Gauge. (If used) 6. Plug the Fuel Pressure Sensor Harness into the back of the Fuel Pressure Gauge. (If used) 7. Splice the green signal wire from the Transmission Temperature Gauge to the green signal wire from the sensor. (If used) 8. Mount the pillar pod to the truck cab A-pillar, securing it to the installed plastic clip with the supplied screw. Mounting The Pillar Pod SECTION 6 3. 4. 7. PROPER ORIENTATION