1998.5-2002 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved 6 DODGE RAM 24V 5.9L CUMMINS Preparing The Pillar Pod SECTION 5 OPTION A: WITHOUT SPEAKER CUTOUT 1. Remove the factory trim by pulling and releasing the spring clips. 2. Insert the supplied plastic clip into the upper oval hole of the truck cab where the spring clip was secured. OPTION B: WITH SPEAKER CUTOUT OPTION 1. Remove the factory trim by pulling and releasing the spring clips. 2. Remove the speaker from the trim using a flat blade screwdriver. 3. Remove the speaker grill from the trim and install in the pod. Clip the speaker back into the speaker grill. 4. Insert the supplied plastic clip into the upper oval hole of the truck cab where the spring clip was secured. 1. Wrap Teflon Tape clockwise around the brass fitting on the back of the Boost Gauge, then attach the female brass fitting for the boost line using a 13mm wrench. Note: Do not overtighten the fitting. 2. Feed the wires from each gauge into the pillar pod. 3. Insert each gauge into the pod. 4. If using a 3 Gauge Wiring Harness, attach all of the wires. 5. Connect all yellow wires together using a splice connector. 6. Connect all red wires together using a splice connector. 7. Connect all orange wires together using a splice connector. 8. Connect all black wires together using a splice connector. 9. Secure all wires with Zip Ties. A2. & B4. 4.– 8. 1X..
RkJQdWJsaXNoZXIy MTIxODAy