1999-2007 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved 10 FORD SUPER DUTY 7.3/6.0 POWER STROKE 10. 19. 12. 10. Connect all of the orange wires using a splice connector. This enables the dimming function that will lower the brightness of your gauges 30% for easier viewing when driving at night. 11. Connect all of the black wires using a splice connector. 12. Secure all wires with Zip Ties. 13. Route the wires through the firewall and into the cab of the truck, keeping clear of any moving parts. Note: You may need to drill a hole in the firewall if there isn't one already. It is important to use a grommet on the hole to ensure the wires are not sliced or cut on the firewall. 14. Insert the boost line into the Ferrule Fitting Adapter, thread onto the back of the gauge and tighten with a 3/8” Wrench. (Refer to diagram below) Note: Do not overtighten the Ferrule Fitting. 15. Plug the EGT Sensor Harness into the back of the EGT Gauge. (If used) 16. Splice the green signal wire from the Transmission Temperature Gauge to the green signal wire from the sensor. (If used) 17. Plug the Fuel Pressure Sensor Harness into the back of the Fuel Pressure Gauge. (If used) 18. Splice the signal wire from the ICP Sensor to the green signal wire from the High Pressure Oil Pressure Gauge. (If used) 19. Mount the pillar pod and factory trim assembly to the truck cab A-pillar, securing it with the factory spring clips. Note: For 2003-2007 trucks the grab handle, bolts and screws will no longer be used. PROPER ORIENTATION
RkJQdWJsaXNoZXIy MTIxODAy