1999-2007 INSTALLATION GUIDE 9 GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved FORD SUPER DUTY 7.3/6.0 POWER STROKE Installing the Pillar Pod SECTION 6 1. Remove the Factory A-Pillar Trim. A. Non-Grab Handle Installation ('99–'02) 1. Carefully remove the factory trim from the truck by pulling and releasing the spring clips. Note: This gauge pod mounts directly on top of your truck's A-pillar using the supplied push-in clips and is not a complete replacement. B. Grab Handle Installation ('03–'07) 1. Using a flat head screwdriver, remove the bolt covers on the grab handle. 2. Remove the 4 bolts on the grab handle using a 10mm socket. 3. Remove the A-pillar by releasing the spring clips. 4. Using a #2 Phillips Head Screwdriver, remove the 2 screws securing the handle from the backside of the A-pillar. Both 1. Place the triple pillar pod overtop of the removed factory trim. 2. Mark and drill (4) 7/32” holes and secure with the flush mount fasteners. 3. Mark and drill holes using a step bit for the wiring to pass through the factory trim. 4. Wrap Teflon tape around the brass fitting on the back of the Boost Gauge, then attach the female brass fitting for the boost line using a 13mm wrench. Note: Do not overtighten. 5. Feed the wires from each gauge into the pillar pod. 6. Insert each gauge into the pod. 7. If you are using the optional 3 or 4 Gauge Wiring Kit, attach all of the wires together. 8. Connect all of the yellow wires using a splice connector. 9. Connect all of the red wires using a splice connector. A1. B2. 3.
RkJQdWJsaXNoZXIy MTIxODAy