2010-2018 INSTALLATION GUIDE 5 GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved RAM 6.7L CUMMINS 11. 13. 14. 10. Once the Big Line Hose is ready, thread the pressure sensor into the Snubber Valve and tighten using 18mm and 22mm Wrenches. Then thread the Snubber Valve into the T-fitting and tighten using an 18mm Wrench. Note: Before installing the fuel pressure sensor, be sure to wrap Teflon Tape or thread sealant on the required Snubber Valve’s male threads. Tighten until snug to avoid any fuel leaks. 11. Remove the injection pump feed line fitting using a 17mm Wrench and then install the AN fitting using the 17mm Wrench. 12. Install the quick disconnect of the Big Line Kit to the bottom of the fuel filter housing. 13. Tighten the AN connector to the AN fitting with a 17mm Wrench. 14. Insert the sensor harness into the sensor until the harness clips in place. Route the sensor harness up to the firewall to the driver side of the engine bay and use Zip Ties to secure the sensor harness. Ensure there is no contact with any direct heat source or moving parts.
RkJQdWJsaXNoZXIy MTIxODAy