GlowShift | 1994-1997 Dodge Ram Cummins 12v Installation Guide

1994-1997 INSTALLATION GUIDE 1 GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved DODGE RAM 12V CUMMINS Boost Gauge Installation SECTION 1 PREPARING THE INSTALLATION • Check that you have all parts required for installation, and that the engine is cool. • Open the hood and locate the truck’s batteries. Using a wrench, disconnect the negative terminal of each battery to ensure there is no power running through the truck during the installation. Note: When it comes time to wire and connect the gauges to their power source, we will reconnect the negative terminals on the batteries. 1. Using an 11mm wrench, remove the intake plug located under the intake horn. 2. Wrap Te on tape around the 1/8-27 NPT male threads of the boost line fitting. 3. Thread and tighten the male end of the boost line fitting into the intake port using an 11mm wrench. 4. Insert the boost line fitting cap on the boost line followed by the ferrule. 5. Insert the boost line into the boost line fitting and tighten the cap with a 3/8” wrench. Note: Do not over tighten the ferrule fitting. 6. Route the boost line to an opening on the firewall on the driver’s side of the engine bay and use Zip Ties to secure. Make sure there is no contact with any direct heat source or moving parts of the truck. Note: If you are installing a MaxTow Boost Gauge, you will be installing an electronic Boost Pressure Sensor and Harness instead of the Boost Line and Ferrule Fittings. An additional 45° fitting will be needed. 1. 3. 5. PROPER ORIENTATION Note

RkJQdWJsaXNoZXIy MTIxODAy