2010-2018 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved RAM 6.7L CUMMINS 8 15. 16. 19. 14. Insert the boost line fitting cap on the boost line followed by the ferrule. 15. Insert the boost line into the boost line fitting and tighten the cap with a 3/8” wrench. Note: Do not overtighten the Ferrule Fitting. (Refer to diagram below) 16. Plug the EGT Sensor Harness into the back of the EGT Gauge. (If used) 17. Splice the Green signal wire from the Transmission Temperature Gauge to the signal wire from the sensor. (If used) 18. Plug the Rail Pressure Harness into the back of the Rail Pressure Gauge. (If used) 19. Install the new A-pillar gauge pod with the gauges mounted using the supplied bolt in the upper factory mounting location. To ensure a proper fit, screw the bolt into the threads, but do not completely tighten it. Adjust the gauge pod so that it lines up correctly and then tighten the bolt using a 4mm Allen Key. Note: Do not overtighten the bolt because it will cause the pod to bow. If this happens, loosen the bolt to refit the pod and tighten the bolt when the pod is properly aligned. PROPER ORIENTATION
RkJQdWJsaXNoZXIy MTIxODAy