2003-2009 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved DODGE RAM 24V 5.9/6.7L CUMMINS 4 Warning : Be sure that the transmission is cool before removing the transmission cooler line. The transmission temperature gauge can be installed in one of two ways: using a transmission test port extender adapter or by using a 1/2” transmission line T-fitting adapter. On 03-07.5 48RE Transmissions either a Test Port Extender or Transmission T-Fitting adapter can be used. On 07.5-09 68RFE Transmissions ONLY a Transmission T-Fitting can be used. See Page 6. TRANSMISSION TEST PORT EXTENDER INSTALLATION: 1. Safely jack up the truck, if not raised already. Locate the middle test port plug on the passenger side of the transmission case. Using an 11mm Wrench, remove the test port plug. Note: Have a drain pan available for any fluid that will leak from the fitting. 2. Wrap Teflon Tape on the male threads of the sensor and test port extender adapter. Thread the sensor into the test port extender adapter and tighten using a 17mm Wrench and 14mm Wrench. 3. Thread the test port extender with the sensor attached into the transmission test port and tighten using a 17mm Wrench. 3. TEST PORT EXTENDER 1a. 1b. Transmission Temp Gauge Installation SECTION 3
RkJQdWJsaXNoZXIy MTIxODAy