2003-2009 Dodge Ram Install Guide

2003-2009 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved DODGE RAM 24V 5.9/6.7L CUMMINS TOOL LIST • Safety Glasses • Gloves • Adjustable Wrenches • Flathead Screwdriver • Center Punch • Marker • Drill & Drill Bits • Size R Drill Bit • 1/8-27 NPT Tap • Tap Handle • Multi-Meter • Wiring Strippers ACCESSORIES • Zip Ties • Grommet • Drain Pan • Teflon Tape • Wire Connectors • Heat Shrink • Anti-Seize • Snubber Valve • Banjo Bolt Adapter TABLE OF CONTENTS SECTION 1 Preparing The Installation 1 SECTION 2 Boost Gauge Installation 2 SECTION 3 Pyrometer EGT Gauge Installation 4 SECTION 4 Transmission Temperature Gauge Installation 5 SECTION 5 Fuel Pressure Gauge Installation 7 SECTION 6 Wiring The Gauges 8 SECTION 7 Installing The Pillar Pod 9 • Crimper • 11, 13, 14, 17mm Wrenches • 3/8”, 5/8”, 7/8”, 3/4” Wrenches • 10mm Socket • Torque Wrench • Pipe Cutter • Deburring Tool • Jack • Jack Stands • Transmission Fluid • 3 Gauge Wiring Kit • Boost Bolt Adapter • Test Port Extender or 1/2” Transmission Line T-Fitting Adapter • Mini Expandable Circuits For installation of MaxTow Gauges please note that the wire colors on the gauge power harnesses are different than what is written in this installation guide. Red is going to be your constant 12v source. White is going to be your 12v ignition switched source. Orange is going to be your 12v headlight switched source. Black is going to be your ground. Please follow the same installation steps for the boost gauge but instead of installing the brass compression fittings and boost line, thread the 1/8-27 NPT boost sensor into your desired location and tighten the sensor with a 22mm wrench. Please not that in some applications additional adapters may be needed in order to adjust or fit the sensor in your desired location. Wiring Schematic Red: 12v Constant Source (+) White: 12v Ignition Switched Source (+) Orange: 12v Headlight Switched Source (+) Black: Vehicle/Engine Ground (-)

RkJQdWJsaXNoZXIy MTIxODAy