1995-1998 INSTALLATION GUIDE GlowShift.com © GlowShift Gauges, LLC | All Rights Reserved 6.5L TURBO DIESEL 2 Boost Gauge Installation SECTION 2 The Boost Gauge can be installed one of two ways: The first is using a 6.5L Boost Bolt Adapter that threads into the Intake Manifold and replaces the Rear Middle Intake Manifold Bolt. The second option applies if you did not purchase an adapter and would like to install the Boost Line directly to the manifold by drilling and tapping the Intake Manifold to 1/8-27 NPT. Option 1: BOOST BOLT INSTALLATION 1. Locate and remove the Rear Intake Manifold Bolt using a 10mm Socket. 2. Apply Teflon Tape to the Ferrule Fitting Adapter. Wrap the tape clockwise on the male threads. 3. Thread the Ferrule Fitting Adapter into the Boost Bolt, and tighten using an 11mm Wrench. 4. Thread the Boost Bolt Adapter into the Intake Manifold and tighten with the 16mm torque Wrench to 17 ft lbs. Note: The Boost Bolt Adapter allows you to replace the existing bolt in the factory location. 5. Slide the Ferrule Fitting Cap and Ferrule onto the Boost Line. (Refer to diagram below) 6. Insert the line into the Ferrule Fitting Adapter and tighten with a 3/8” Wrench. Note: Do not overtighten the Ferrule Fitting. 7. Route the Boost Hose, without kinking, up to the firewall on the driver side of the engine bay and use Zip Ties to secure the Boost Hose. Make sure there is no contact with any direct heat source or moving parts. 1. 3. 6. PROPER ORIENTATION
RkJQdWJsaXNoZXIy MTIxODAy